Wooden Eyes
In stick making, any distinction between pupil and iris colour in very small subjects, is really only perceptible when examined very closely. While in the case of a mouse for instance, the eyes are completely black. In either case these simple black wooden eyes, used as inserts, work nicely. You can vary their diameter to suit your carving exactly. Though I’ve never bothered trying, I suppose you could alter the eye design and paint a black pupil with coloured iris, but that’s an experiment I’ll leave to you.
Project Materials
- Small piece of timber, approximately 200mm x15mm x 15mm
- Black wood stain (I use Chestnut Products' Spirit Wood Stain)
- Fast cure epoxy glue
- Blu Tack
- Sandpaper (course (80-120grit) and/or fine (240-320grit))
Tools required
- Small round No. 1 brush
- Wood carving knife e.g. Mora 160
- Drill gauge
- Bottle holder (for the stain)
Care
- Wear nitrile gloves or similar, to keep glue and stain off your hands.
- Consider wearing carving gloves if you are inexperienced using a carving knife.
- Keep your work area ventilated when using spirit wood stain or any materials with VOCs (Volatile Organic Compounds).
- Secure the bottle of stain in a holder of some sort OR at least put it in the middle of a large tray when using it. It’s easy to knock an unsecured bottle over and the resulting spill will at best, cause havoc.
Step 1
Lay out your tools and materials, putting the wood stain bottle in a holder.
Step 2
With the carving knife, roughly whittle 25mm of your piece of timber, down to a 5 or 6mm diameter dowel.
Step 3
Push the rough dowel through the nearest hole size in a drill gauge.
Step 4
Push the dowel through successively smaller diameters in your drill gauge until, in this case, you have got it down to 4mm.
Step 5
Lightly smooth the dowel with sandpaper.
Step 6
Using sandpaper, round the end of the dowel to a dome profile. Finish with fine sandpaper.
Step 7
Cut the rounded tip of the dowel off to a length of 5 or so millimetres.
Step 8
Round the end of the remaining dowel similar to the first.
Step 9
Again, cut the rounded tip of the dowel off to a length like the previous (see step 7).
Step 10
Stick both the dowels, by their cut ends, to a piece of Blu Tack.
Step 11
Paint the domed end of the dowels with black stain.
Step 12
When dry, apply a little yacht varnish or clear epoxy over the blackened dowel ends.
Step 13
Allow to dry.
Finally
In your animal carving, these can now be inserted into suitable diameter eye sockets. The wren at the start of this article has just such eyes. I that case they were secured in the bird by forming an eye ring with epoxy putty. You might prefer just to glue them in position leaving a separation line between the eye socket and the eye.